ROUTER 0
Router>en
Router#conf t
Router(config)#int fa0/0
Router(config-if)#ip add 172.16.3.1
255.255.255.0
Router(config-if)#no shut
Router(config-if)#exit
Router(config)#int s2/0
Router(config-if)#ip add 172.16.2.1
255.255.255.0
Router(config-if)#clock rate 64000
Router(config-if)#no shut
Router(config-if)#exit
Router(config)#
Router(config)#ip route 172.16.1.0
255.255.255.0 s2/0
Router(config)#ip route 192.168.0.0
255.255.252.0 s2/0
Router(config)#exit
ROUTER 1
Router>en
Router#conf t
Router(config)#int fa0/0
Router(config-if)#ip add 172.16.1.1
255.255.255.0
Router(config-if)#no shut
Router(config-if)#exit
Router(config)#int s2/0
Router(config-if)#ip add 172.16.2.2
255.255.255.0
Router(config-if)#no shut
Router(config-if)#exit
Router(config)#int s3/0
Router(config-if)#ip add 192.168.1.1
255.255.255.0
Router(config-if)#clock rate 64000
Router(config-if)#no shut
Router(config-if)#exit
Router(config)#ip route 172.16.3.0
255.255.255.0 s2/0
Router(config)#ip route 192.168.2.0 255.255.255.0
s3/0
Router(config)#exit
ROUTER 2
Router>en
Router#conf t
Router(config)#int f0/0
Router(config-if)#ip add 192.168.2.1
255.255.255.0
Router(config-if)#no shut
Router(config-if)#exit
Router(config)#int s2/0
Router(config-if)#ip add 192.168.1.2 255.255.255.0
Router(config-if)#no shut
Router(config-if)#exit
Router(config)#ip route 172.16.0.0
255.255.252.0 s2/0
Router(config)#exit
Troubleshooting router 0
Router#PING 192.168.2.40
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 192.168.2.40,
timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip
min/avg/max = 14/18/27 ms
Router#traceroute 172.16.1.25
Type escape sequence to abort.
Tracing the route to 172.16.1.25
1 172.16.2.2 11 msec
5 msec 5 msec
2 172.16.1.25 18 msec
15 msec 14 msec
Router#sh ip route
Codes: C - connected, S - static, I - IGRP, R
- RIP, M - mobile, B - BGP
D
- EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP
i
- IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area
*
- candidate default, U - per-user static route, o - ODR
P
- periodic downloaded static route
Gateway of last resort is not set
172.16.0.0/24 is subnetted, 3 subnets
S
172.16.1.0 is directly connected, Serial2/0
C
172.16.2.0 is directly connected, Serial2/0
C
172.16.3.0 is directly connected, FastEthernet0/0
S
192.168.0.0/22 is directly connected, Serial2/0
Router#sh ip int brief
Interface IP-Address OK? Method Status Protocol
FastEthernet0/0 172.16.3.1 YES manual up up
FastEthernet1/0 unassigned YES unset
administratively down down
Serial2/0 172.16.2.1 YES manual up up
Serial3/0 unassigned YES unset
administratively down down
FastEthernet4/0 unassigned YES unset
administratively down down
FastEthernet5/0 unassigned YES unset
administratively down down
Router#sh cdp neighbors detail
Device ID: Switch
Entry address(es):
Platform: cisco 2950, Capabilities: Switch
Interface: FastEthernet0/0, Port ID (outgoing
port): FastEthernet0/2
Holdtime: 161
Version :
Cisco Internetwork Operating System Software
IOS (tm) C2950 Software (C2950-I6Q4L2-M),
Version 12.1(22)EA4, RELEASE SOFTWARE(fc1)
Copyright (c) 1986-2005 by cisco Systems, Inc.
Compiled Wed 18-May-05 22:31 by jharirba
advertisement version: 2
Duplex: full
---------------------------
Device ID: Router
Entry address(es):
IP
address : 172.16.2.2
Platform: cisco PT1000, Capabilities: Router
Interface: Serial2/0, Port ID (outgoing port):
Serial2/0
Holdtime: 123
Version :
Cisco Internetwork Operating System Software
IOS (tm) PT1000 Software (PT1000-I-M), Version
12.2(28), RELEASE SOFTWARE (fc5)
Technical Support:
http://www.cisco.com/techsupport
Copyright (c) 1986-2005 by cisco Systems, Inc.
Compiled Wed 27-Apr-04 19:01 by miwang
advertisement version: 2
Duplex: full
Troubleshooting router 1
Router#ping 172.16.3.20
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 172.16.3.20,
timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip
min/avg/max = 6/16/27 ms
Router#traceroute 192.168.2.40
Type escape sequence to abort.
Tracing the route to 192.168.2.40
1 192.168.1.2 7 msec
3 msec 10 msec
2 192.168.2.40 10 msec
12 msec 5 msec
Router#sh ip route
Codes: C - connected, S - static, I - IGRP, R
- RIP, M - mobile, B - BGP
D
- EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP
i
- IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area
*
- candidate default, U - per-user static route, o - ODR
P
- periodic downloaded static route
Gateway of last resort is not set
172.16.0.0/24 is subnetted, 3 subnets
C
172.16.1.0 is directly connected, FastEthernet0/0
C
172.16.2.0 is directly connected, Serial2/0
S
172.16.3.0 is directly connected, Serial2/0
C
192.168.1.0/24 is directly connected, Serial3/0
S
192.168.2.0/24 is directly connected, Serial3/0
Router#sh ip int brief
Interface IP-Address OK? Method Status Protocol
FastEthernet0/0 172.16.1.1 YES manual up up
FastEthernet1/0 unassigned YES unset
administratively down down
Serial2/0 172.16.2.2 YES manual up up
Serial3/0 192.168.1.1 YES manual up up
FastEthernet4/0 unassigned YES unset
administratively down down
FastEthernet5/0 unassigned YES unset
administratively down down
Router#sh cdp neighbors detail
Device ID: Switch
Entry address(es):
Platform: cisco 2950, Capabilities: Switch
Interface: FastEthernet0/0, Port ID (outgoing
port): FastEthernet0/2
Holdtime: 155
Version :
Cisco Internetwork Operating System Software
IOS (tm) C2950 Software (C2950-I6Q4L2-M),
Version 12.1(22)EA4, RELEASE SOFTWARE(fc1)
Copyright (c) 1986-2005 by cisco Systems, Inc.
Compiled Wed 18-May-05 22:31 by jharirba
advertisement version: 2
Duplex: full
---------------------------
Device ID: Router
Entry address(es):
IP
address : 172.16.2.1
Platform: cisco PT1000, Capabilities: Router
Interface: Serial2/0, Port ID (outgoing port):
Serial2/0
Holdtime: 130
Version :
Cisco Internetwork Operating System Software
IOS (tm) PT1000 Software (PT1000-I-M), Version
12.2(28), RELEASE SOFTWARE (fc5)
Technical Support:
http://www.cisco.com/techsupport
Copyright (c) 1986-2005 by cisco Systems, Inc.
Compiled Wed 27-Apr-04 19:01 by miwang
advertisement version: 2
Duplex: full
---------------------------
Device ID: Router
Entry address(es):
IP
address : 192.168.1.2
Platform: cisco PT1000, Capabilities: Router
Interface: Serial3/0, Port ID (outgoing port):
Serial2/0
Holdtime: 146
Version :
Cisco Internetwork Operating System Software
IOS (tm) PT1000 Software (PT1000-I-M), Version
12.2(28), RELEASE SOFTWARE (fc5)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2005 by cisco Systems, Inc.
Compiled Wed 27-Apr-04 19:01 by miwang
advertisement version: 2
Duplex: full
Troubleshooting router 2
Router#ping 172.16.3.20
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 172.16.3.20,
timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip
min/avg/max = 14/40/66 ms
Router#traceroute 172.16.1.25
Type escape sequence to abort.
Tracing the route to 172.16.1.25
1 192.168.1.1 3 msec
2 msec 6 msec
2 172.16.1.25 10 msec
10 msec 13 msec
Router#sh ip route
Codes: C - connected, S - static, I - IGRP, R
- RIP, M - mobile, B - BGP
D
- EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP
i
- IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area
*
- candidate default, U - per-user static route, o - ODR
P
- periodic downloaded static route
Gateway of last resort is not set
172.16.0.0/22 is subnetted, 1 subnets
S
172.16.0.0 is directly connected, Serial2/0
C
192.168.1.0/24 is directly connected, Serial2/0
C
192.168.2.0/24 is directly connected, FastEthernet0/0
Router#sh int brief
^
% Invalid input detected at '^' marker.
Router#sh ip int brief
Interface IP-Address OK? Method Status Protocol
FastEthernet0/0 192.168.2.1 YES manual up up
FastEthernet1/0 unassigned YES unset
administratively down down
Serial2/0 192.168.1.2 YES manual up up
Serial3/0 unassigned YES unset
administratively down down
FastEthernet4/0 unassigned YES unset
administratively down down
FastEthernet5/0 unassigned YES unset
administratively down down
Router#sh cdp neighbors detail
Device ID: Switch
Entry address(es):
Platform: cisco 2950, Capabilities: Switch
Interface: FastEthernet0/0, Port ID (outgoing
port): FastEthernet0/2
Holdtime: 147
Version :
Cisco Internetwork Operating System Software
IOS (tm) C2950 Software (C2950-I6Q4L2-M),
Version 12.1(22)EA4, RELEASE SOFTWARE(fc1)
Copyright (c) 1986-2005 by cisco Systems, Inc.
Compiled Wed 18-May-05 22:31 by jharirba
advertisement version: 2
Duplex: full
---------------------------
Device ID: Router
Entry address(es):
IP
address : 192.168.1.1
Platform: cisco PT1000, Capabilities: Router
Interface: Serial2/0, Port ID (outgoing port):
Serial3/0
Holdtime: 130
Version :
Cisco Internetwork Operating System Software
IOS (tm) PT1000 Software (PT1000-I-M), Version
12.2(28), RELEASE SOFTWARE (fc5)
Technical Support:
http://www.cisco.com/techsupport
Copyright (c) 1986-2005 by cisco Systems, Inc.
Compiled Wed 27-Apr-04 19:01 by miwang
advertisement version: 2
Duplex: full
Learn complete process on Linksys Velop how you can login and setup Linksys Velop app, Linksys Mesh wifi router, Linksys Velop login and setup.
BalasHapusIf you are facing error while doing the linksys velop login
BalasHapus, visit our website and take help from our experts.